0
Robotlinking Arduino UNO
4,500 د.ع
Robotlinking Controller Board CH340 Chip, Compatible with Arduino IDE
In stock
CompareDescription
1- 100% compatible with the Arduino IDE.
2- The Robotlinking controller board now uses a CH340C chip and SMD chip (same as ), with a faster transfer rate and more memory
3- Clearly printed pin names on the female header connector, are more precise and much easier to use the wires
4- Robotlinking controller board can be powered via a USB connection and an external power supply
5- A good choice for getting started with electronics and coding, and ideal for your 3D printer, robotic and electronic projects
2- The Robotlinking controller board now uses a CH340C chip and SMD chip (same as ), with a faster transfer rate and more memory
3- Clearly printed pin names on the female header connector, are more precise and much easier to use the wires
4- Robotlinking controller board can be powered via a USB connection and an external power supply
5- A good choice for getting started with electronics and coding, and ideal for your 3D printer, robotic and electronic projects
Robotlinking microcontroller board is based on the CH340C, 100% compatible with Arduino. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 inputs, a 16 MHz ceramic resonator, a USB connection, a power jack,an ICSP header, and a reset button. It contains everything you need to support your microcontroller, including new pin configurations (SCL, SDA, IOREF); just connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started. The ATmega328P on the controller board is the same as the official board, and comespre-programmed with a bootloader that allows you to upload new code to it without using an external hardware programmer. The ATmega328P has 32 KB (with 0.5 KB occupied by the bootloader). It also has 2 KB of SRAM and 1 KB of EEPROM (which can be read and written with the EEPROM library). The RX and TX LEDs on the board will flash when data is being transmitted via the USB-to-serial chip and USB connection to the computer. The Robotlinking puts SDA and SCL pins beside the AREF. Besides, there are two new pins placed near the RESET pin. One is the IOREF which allows the shields to adapt to the voltage provided by the board and the other one is reserved for future purposes. The Robotlinking works with all existing shields and can adapt to new shields that use these additional pins.
Be the first to review “Robotlinking Arduino UNO”
Reviews
There are no reviews yet.